View source for MCM-iMX8M-Plus: Evaluation Kit: Getting Started

== System setup ==
MCM-iMX8Plus evaluation kit is preloaded with MCM-iMX8Plus Yocto Linux image.
# Make sure jumper '''E9''' is populated (default state).
# Make sure jumpers '''E19''' and '''E20''' are removed (default state).
# Optional - connect the LCD panel (if ordered with the kit) to connectors '''P11''' and '''P5'''. Ensure that the flat cables are fully inserted.
# Connect a standard USB cable (included in the kit) between your host PC and the evaluation kit micro-USB2.0 connector '''P16'''.
# On your computer, start a terminal emulation program (such as HyperTerminal) with the following serial port settings:
<blockquote>
{{:SB-SOM: serial port parameters table}}
</blockquote>

== Starting the system ==
# Connect the DC 12V power supply adapter (included) to main DC power connector '''J4'''.
# Follow the messages in your terminal emulator program until you see the linux shell command line prompt. 
{{note|In case of no messages appear in your terminal emulation program, please refer to the detailed [[SB-UCM-iMX8: HOWTO: USB Console|USB console]] guide.}}

== What Next? ==
* [https://www.compulab.com/products/computer-on-modules/mcm-imx8m-plus-nxp-i-mx-8m-plus-som-system-on-module/#devres MCM-iMX8M-Plus development resources]

[[Category:MCM-iMX8M-Plus]]