View source for MCM-iMX93: Evaluation Kit: Getting Started

__NOTOC__
[[Image:MCM-iMX93L-eval-kit-quick-setup.png|frameless|top|1300px|link=]]

== System setup ==
MCM-iMX93 evaluation kit is preloaded with the MCM-iMX93 Yocto Linux image.
# Make sure jumper '''E5''' is populated (default state).
# Make sure jumpers '''E3''' and '''E4''' are not populated (default state).
# Make sure that main power switch '''SW1''' is in the '''OFF''' position.
# Optional - use the EB-HDRLVDS adapter to connect the LCD panel (if ordered with the kit) to connectors '''P13''' and '''P14'''.
# Connect a standard USB cable (included in the kit) between your host PC and the evaluation kit console connector '''P3'''.
# On your computer, start a terminal emulation program (such as [https://www.putty.org/ PuTTY] on Windows or minicom on Linux) with the following serial port settings:
<blockquote>
{{:SB-SOM: serial port parameters table}}
</blockquote>

== Starting the system ==
# Connect the DC 12V power supply adapter (included) to main DC power jack '''J1'''.
# Toggle the main power switch '''SW1''' to '''ON''' position.
# Follow the messages in your terminal emulator program until you see the linux shell command line prompt. 
{{note|In case no messages appear in your terminal emulation program, please refer to the detailed [[SB-UCM-iMX8: HOWTO: USB Console|USB console]] guide.}}

== What's Next? ==
* [[MCM-iMX93: Evaluation Kit: Hardware Guide|MCM-iMX93 evaluation kit hardware guide]]
* [https://www.compulab.com/products/computer-on-modules/mcm-imx93-nxp-i-mx-93-som-smd-system-on-module/#devres MCM-iMX93 development resources]

[[Category:MCM-iMX93]]