View source for UCM-iMX93: Evaluation Kit: Getting Started

__NOTOC__
[[Image:UCM-iMX93-eval-kit-quick-setup.png|frameless|top|1600px|link=]]

== Package content ==

[https://www.compulab.com/wp-content/uploads/2023/07/ucm-imx93_eval-kit-content.pdf Package content list]

== System setup ==
UCM-iMX93 evaluation kit is preloaded with the UCM-iMX93 Yocto Linux image.
# Make sure jumper '''E9''' is populated (default state).
# Make sure jumpers '''E2''' and '''E7''' are not populated (default state).
# Optional - connect the LCD panel (if ordered with the kit) to connectors '''P7''' and '''P8'''. Ensure that the flat cables are fully inserted.
# Connect a standard USB cable (included in the kit) between your host PC and the evaluation kit micro-USB2.0 connector '''P16'''.
# On your computer, start a terminal emulation program (such as Tera Term or PuTTy) with the following serial port settings:
<blockquote>
{{:SB-SOM: serial port parameters table}}
</blockquote>

== Starting the system ==
# Connect the DC 12V power supply adapter (included) to main DC power connector '''J4'''.
# Follow the messages in your terminal emulator program until you see the linux shell command line prompt. 
{{note|In case no messages appear in your terminal emulation program, please refer to the detailed [[SB-UCM-iMX8: HOWTO: USB Console|USB console]] guide.}}

== What's Next? ==
* [https://www.compulab.com/products/computer-on-modules/ucm-imx93-nxp-i-mx9-som-system-on-module-computer/#devres UCM-iMX93 development resources]

[[Category:UCM-iMX93]]