View source for UCM-iMX95 Yocto Linux Guide: Serial Console

The serial console is provided on UART1.</br>
The evaluation carrier-board exposes the console UART via CP2104 serial-to-USB bridge on connector [[UCM-iMX95: Evaluation Kit: Hardware Guide#Connector_Locations | '''P3''']].
== Connecting to a host PC ==
# Use a micro-USB cable to connect the console to the USB port on your host PC.
# Make sure the CP2104 driver is available with your operating system, otherwise install CP2104 driver onto the host PC from https://www.silabs.com/documents/public/software/CP210x_Windows_Drivers_with_Serial_Enumeration.zip
# Identify the host PC interface and port number that will be used for communication with the evaluation kit:
#* In most Linux PCs, the serial port will be denoted as one of the following (where n is a positive integer): /dev/ttyUSB0, /dev/ttyUSB1 ... /dev/ttyUSBn
#* In Windows PCs, the serial port usually will be denoted as one of the following (where n is a positive integer): COM1, COM2 ... COMn
# Start a terminal emulation program (such as [https://www.putty.org/ PuTTY] on Windows or minicom on Linux).
# In the port configuration section of the terminal emulation program select the port identified in previous step and set the following serial port parameters:
<blockquote>
{{:SB-SOM: serial port parameters table}}
</blockquote>

[[Category:Linux]]
[[Category:Yocto]]
[[Category:UCM-iMX95]]