View source for WES7: Preparing the UFD to boot the WinPE

== Preparing the UFD ==
* Attach a UFD to the development workstation.<br>'''Important Notes:'''
** The UFD’s capacity must be at least 8GB.
** The UFD will be repartitioned and formatted. Backup all necessary data before proceeding to the next step.
* On the development workstation open the command prompt in the administrative mode.
* In the command prompt type:
<pre>diskpart</pre>
* In the Diskpart prompt type:
<pre>list disk</pre>
* From the list displayed, determine the disk number of the USB disk attached.<br>In the example below, disk 3 is the UFD:
<pre>
Microsoft Windows [Version 6.1.7601]
Copyright (c) 2009 Microsoft Corporation.  All rights reserved.

C:\Windows\System32>diskpart

Microsoft DiskPart version 6.1.7601
Copyright (C) 1999-2008 Microsoft Corporation.
On computer: WORKSTATION-PC

DISKPART> list disk

  Disk ###  Status         Size     Free     Dyn  Gpt
  --------  -------------  -------  -------  ---  ---
  Disk 0    Online          465 GB  1024 KB
  Disk 1    Online          465 GB      0 B
  Disk 2    Online          931 GB      0 B
  Disk 3    Online         7663 MB      0 B

DISKPART>
</pre>
* In the Diskpart prompt type:
<pre>select disk [disk number] (disk 3 in this case)</pre>
&nbsp;&nbsp; '''Important Note:''' Make the selection very carefully. All data contained in the selected drive will be '''OVERWRITTEN'''!
<br>&nbsp;&nbsp; The output should be:
<pre>Disk [disk number] is now the selected disk. (disk 3 in this case)</pre>

* In the Diskpart prompt type:
<pre>clean</pre>
&nbsp;&nbsp; The output should be:
<pre>DiskPart succeeded in cleaning the disk.</pre>

* In the Diskpart prompt type:
<pre>create partition primary</pre>
&nbsp;&nbsp; The output should be:
<pre>DiskPart succeeded in creating the specified partition.</pre>

* In the Diskpart prompt type:
<pre>format fs=ntfs quick</pre>
&nbsp;&nbsp; The output should be:
<pre>100 percent completed
DiskPart successfully formatted the volume.</pre>

* In the Diskpart prompt type:
<pre>active</pre>
&nbsp;&nbsp; The output should be:
<pre>DiskPart marked the current partition as active.</pre>

* In the Diskpart prompt type:
<pre>assign</pre>
&nbsp;&nbsp; The output should be:
<pre>DiskPart successfully assigned the drive letter or mount point.</pre>

* In the Diskpart prompt type:
<pre>exit</pre>
&nbsp;&nbsp; The output should be:
<pre>Leaving DiskPart...</pre>


[[Category:Windows Embedded Standard]]