https://mediawiki.compulab.com/w/index.php?action=history&feed=atom&title=CM-T3730%3A_WEC7%3A_Getting_StartedCM-T3730: WEC7: Getting Started - Revision history2026-09-02T08:20:56ZRevision history for this page on the wikiMediaWiki 1.31.0https://mediawiki.compulab.com/w/index.php?title=CM-T3730:_WEC7:_Getting_Started&diff=1492&oldid=prevNadav: /* Creating a bootable SD card */2013-01-31T11:20:46Z<p><span dir="auto"><span class="autocomment">Creating a bootable SD card</span></span></p>
<p><b>New page</b></p><div>== Connecting the module ==<br />
The following picture shows the recommended evaluation kit setup for the SB-T3X.<br />
:- [[Image:CM T35 Properly Connected Image.jpg]]<br />
{{Note|In the CM-T3730 the SD card is installed on the module's micro SD slot (P5)}}<br />
<br />
== Creating a bootable SD card ==<br />
{{Note | The TI SDCard boot utility does not work well on computers running Windows 7, use Windows XP (WinXP mode in Windows 7 works fine too.)}}<br />
* Download the latest [http://compulab.co.il/products/computer-on-modules/cm-t3730/#devres WEC 7.0 runtime image for CM-T3730] and unzip the file.<br />
* Use the TI_SDCard_boot_utility to create a disk with partition table geometry compatible with the OMAP3 boot ROM. <br />
: Follow the steps below:<br />
# Insert the SD card into an SD-Reader attached to the desktop computer (an SD-card is supplied with the CM-T3730 evaluation kit).<br />
# Launch the TI_SDCard_boot utility (located in the {{filename|Utils}} folder).<br />
# Choose the drive letter of the SD reader. <br> [[Image:Format SD card step 1.jpg|350px]]<br><br />
# Select the {{filename|MLO}} file from the LiveDisk folder.<br> [[Image:Format SD card step 2.jpg|350px]]<br><br />
# Select the rest of the files in the LiveDisk folder.<br> [[Image:Format SD card step 3.jpg|350px]]<br><br />
# Select the {{parameter|FAT 32}} filesystem and {{parameter|4096 bytes}} allocation unit size in the {{cmd|Format Removable Disk}} pop-up and start the SD card format process.<br> [[Image:Format SD card step 4.jpg|200px]]<br><br />
# After the formatting is complete, the utility automatically starts to copy the files to the SD card. <br />
# Wait for the "Copying files done" message to appear in the debug output box. <br>[[Image:Format SD card step 5.jpg|350px]]<br><br />
# Your SD card is now ready to boot the CM-T3730.<br />
<br />
== Booting the system ==<br />
* Install the bootable SD card on the CM-T3730 micro SD slot (P5).<br />
* Power on the device. A synthetic splash-screen (4 colored squares) will appear on LCD display within a few seconds.<br />
* The CompuLab WinCE demo image is loaded from the SD card.<br />
<br />
== See also ==<br />
*[http://wiki.omap.com/index.php/SD/MMC_format_for_OMAP3_boot SD/MMC format for OMAP3 boot]<br />
<br />
[[Category:WEC7|Getting Started]]<br />
[[Category:CM-T3730|WEC7: Getting Started]]</div>Nadav