Nadav: /* Installing the demo runtime image */

2011-08-30T12:20:36Z

‎Installing the demo runtime image

New page

== Connecting the module ==
The following picture shows the recommended evaluation kit setup
: [[Image:EM-T35 Properly Connected.jpg]]

== Creating a bootable SD card ==
{{Note | The TI SDCard boot utility does not work well on computers running Windows 7, use Windows XP (WinXP mode in Windows 7 works fine too.)}}
* Download the latest [http://compulab.co.il/t3530/download/t3530-wince6-img.zip WinCE 6.0 runtime image for EM-T3530] and unzip the file.
* Use the TI_SDCard_boot_utility to create a disk with partition table geometry compatible with the OMAP3 boot ROM.
: Follow the steps below:
# Insert the SD card into an SD-Reader attached to a desktop computer (an SD-card is supplied with the EM-T3530 evaluation kit).
# Launch the TI_SDCard_boot utility (located in the {{filename|Utils}} folder).
# Choose the drive letter of the SD reader. [[Image:Format SD card step 1.jpg|350px]] 
# Select the {{filename|MLO}} file from the LiveDisk folder. [[Image:Format SD card step 2.jpg|350px]] 
# Select the rest of the files in the LiveDisk folder. [[Image:Format SD card step 3.jpg|350px]] 
# Select the {{parameter|FAT 32}} filesystem and {{parameter|4096 bytes}} allocation unit size in the {{cmd|Format Removable Disk}} pop-up and start the SD card format process. [[Image:Format SD card step 4.jpg|200px]] 
# After the formatting is complete press "Close", the utility automatically starts to copy the files to the SD card.
# Wait for the "Copying files done" message to appear in the debug output box. [[Image:Format SD card step 5.jpg|350px]] 
# Your SD card is now ready to boot the EM-T3530.

== Installing the demo runtime image ==
* Insert the bootable SD card into the SD socket (connector P11 on the EM-T3530).
* Power on the device by pressing SW1. The synthetic splash-screen (4 colored squares) will appear on LCD display within a few seconds.
* An Updater image (dedicated WinCE image) is loaded from the SD-Card. The updater image boot time is approximately 50 seconds.
* The Updater utility starts automatically. The utility installs the runtime image onto the EM-T3530 NAND flash.
:[[Image:CM_T35_Updater_Running.jpg|400px]]
* The following message box informs you that the process is complete.
:[[Image:CM_T35_Updater_Complete.jpg|400px]]
* Remove the SD card. Otherwise, the installation process will be repeated the next time you boot the device.
* Use the reset button (SW2) to reboot the device.
* CompuLab WinCE demo image is loaded from the NAND flash.

{{Note |Please refer to [[CM-T3530: WinCE: Updater| CM-T3530 Updater Guide]] for the technical installation process details}}

== See also ==
*[http://wiki.omap.com/index.php/SD/MMC_format_for_OMAP3_boot SD/MMC format for OMAP3 boot]
*[[CM-T3530: WinCE: Updater]]

[[Category:Windows CE|Getting Started]]
[[Category:EM-T3530|WinCE: Getting Started]]

EM-T3530: WinCE: Getting Started - Revision history

Nadav: /* Installing the demo runtime image */