Igor: Created page with "link= == System setup == MCM-iMX8PV2 evaluation kit is preloaded with MCM-iMX8PV2 Yocto Linux image. # Mak..."

2026-11-08T15:23:41Z

Created page with "frameless|1520px|top|link= == System setup == MCM-iMX8PV2 evaluation kit is preloaded with MCM-iMX8PV2 Yocto Linux image. # Mak..."

New page

[[Image:MCM-iMX8PV2-eval-kit-quick-setup.png|frameless|1520px|top|link=]]

== System setup ==
MCM-iMX8PV2 evaluation kit is preloaded with MCM-iMX8PV2 Yocto Linux image.
# Make sure jumper '''E3''' is removed (default state).
# Make sure that the main power switch '''SW1''' is in the '''OFF''' position.
# For kits ordered with LCD panel: use the '''EB-HDRLVDS''' adapter to connect the LCD panel (if ordered with the kit) to connectors '''P13''' and '''P14'''.
# Connect a standard USB cable (included in the kit) between your host PC and the evaluation kit micro-USB2.0 connector '''P3'''.
# On your computer, start a terminal emulation program (such as HyperTerminal) with the following serial port settings:
<blockquote>
{{:SB-SOM: serial port parameters table}}
</blockquote>

== Starting the system ==
# Connect the DC 12V power supply adapter (included in the kit) to main DC power connector '''J1'''.
# Toggle the main power switch '''SW1''' to '''ON''' position.
# Follow the messages in your terminal emulator program until you see the linux shell command line prompt.
# Use the superuser credentials to log in:
:: user: root<br>
:: pass: no password
{{note|In case of no messages appear in your terminal emulation program, please refer to the detailed [[SB-UCM-iMX8: HOWTO: USB Console|USB console]] guide.}}

== What Next? ==
* [https://www.compulab.com/products/computer-on-modules/mcm-imx8pv2-nxp-i-mx-8m-plus-som-smd-system-on-module/#devres MCM-iMX8PV2 development resources]

[[Category:MCM-iMX8PV2]]

MCM-iMX8PV2: Evaluation Kit: Getting Started - Revision history

Igor: Created page with "link= == System setup == MCM-iMX8PV2 evaluation kit is preloaded with MCM-iMX8PV2 Yocto Linux image. # Mak..."