Grinberg at 11:04, 5 June 2017

2017-06-05T11:04:26Z

New page

[[Image:SB_UCM_topview.jpg|thumb|right|alt=SB-UCM top view|<div align="center">SB-UCM top view</div>]]
[[Image:SB_UCM_bottomview.jpg|thumb|right|alt=SB-UCM bottom view|<div align="center">SB-UCM bottom view</div>]]

== Setting up your host PC ==
# Connect a micro-USB cable (included with the evaluation kit) between the SBC connector '''P7''' to a free USB port on your host PC.
# Make sure the CP2104 driver is available with your operating system, otherwise install CP2104 driver onto the host PC from here: https://www.silabs.com/products/mcu/Pages/USBtoUARTBridgeVCPDrivers.aspx
# Identify the host PC interface and port you will be using for communication with the SBC:
#* For Linux hosts, the serial port in most cases would be called like one of the following (where n is a positive integer): {{filename|/dev/ttyUSB0}}, {{filename|/dev/ttyUSB1}} ... {{filename|/dev/ttyUSBn}}
#* For Windows Hosts, the serial port in most cases would be called like one of the following (where n is a positive integer): ''COM1'', ''COM2'' ... ''COMn''
# Start a terminal emulation program (such as HyperTerminal on Windows or minicom on Linux).
# Within the terminal emulation program, in the serial port configuration section select the port identified in previous step and set the following serial port parameters:
<blockquote>
{{:SB-SOM: serial port parameters table}}
</blockquote>

== Setting up the Compulab Board ==
# Start the system by enabling power through the main DC power connector.
# Console messages should appear on your host PC through the terminal emulation program.

[[Category:SB-UCM]]

SB-UCM: HOWTO: USB Console - Revision history

Grinberg at 11:04, 5 June 2017