Grinberg: /* What Next? */

2017-06-07T11:27:31Z

‎What Next?

New page

[[Image:UCM-iMX7-eval-kit-quick-setup.jpg|800px]]
[[Image:SB_UCM_topview.jpg|thumb|right|alt=SB-UCM top view|<div align="center">SB-UCM top view</div>]]

== System setup ==
[[Image:SB_UCM_bottomview.jpg|thumb|right|alt=SB-SOM bottom view|<div align="center">SB-UCM bottom view</div>]]
UCM-iMX7 evaluation kit is preloaded with Debian Linux image for UCM-iMX7.
# Connect a DVI/HDMI Display to HDMI connector '''J5''' using a standard HDMI/DVI cable.
# Connect a USB Keyboard to USB connector '''P6'''.
# Make sure jumper '''E1''' is not populated (default state).
# Connect the standard USB cable (included) between your host PC and the evaluation kit micro-USB2.0 connector '''P7'''.
# On your computer, start a terminal emulation program (such as HyperTerminal) with the following serial port settings:
<blockquote>
{{:SB-SOM: serial port parameters table}}
</blockquote>

== Starting the system ==
# Connect the DC 12V power supply adapter (included) to main DC power connector - '''J6'''.
# Follow the messages in your terminal emulator program until you see the linux login prompt.
# Use the credentials below to login.
:* username: root
:* password: 111111
{{note|In case no messages appear in your terminal emulation program, please refer to the detailed [[SB-SOM: HOWTO: USB Console|USB console]] guide.}}

== What Next? ==


* [[UCM-iMX7: Evaluation Kit: Hardware Guide|UCM-iMX7 evaluation kit hardware guide]]
* [http://www.compulab.com/products/computer-on-modules/ucm-imx7-nxp-i-mx-7-ultra-miniature-system-on-module/#devres UCM-iMX7 development resources]

[[Category:SB-UCM]]
[[Category:UCM-iMX7]]

UCM-iMX7: Evaluation Kit: Getting Started - Revision history

Grinberg: /* What Next? */