|
|
| (One intermediate revision by one other user not shown) |
| Line 1: |
Line 1: |
| | {{IssueCategory|Multiple environment storage devices| | | {{IssueCategory|Multiple environment storage devices| |
| − | * After switching the environment storage device using {{parameter|env device}} command, U-Boot might print an incorrect message when saving the environment, reporting the destination storage device as the original boot storage device. | + | * After using usb commands in U-Boot, Linux might fail to detect USB devices. |
| − | : This can be ignored; the environment will be saved to the correct storage device (as reported by the {{parameter|env device}} command).
| + | : '''Workaround:''' Reset the module before booting Linux. This can be done using the reset button (SW2) or the U-Boot command {{cmd|reset}}. |
| − | * While using CM-T3730, with on-board micro SD card, on the CB-T3 baseboard or the SB-T35 baseboard, with alternate boot selected, the boot process will default to the CM-T3730 primary storage (micro SD card), but U-Boot will still expect to find the environment in the external NAND flash.
| |
| − | : '''Workaround:''' Use the {{parameter|env device}} command to switch to the primary CM-T3730 storage:<pre>> env device mmc import</pre> | |
| − | * While using CM-T3730, with on-board NAND flash, on the CB-T3 baseboard or the SB-T35 baseboard, with alternate boot selected, and the MMC card is not present in the socket, the boot process will default to the CM-T3730 primary storage (NAND flash), but U-Boot will still expect to find the environment in the MMC card.
| |
| − | : '''Workaround:''' Use the {{parameter|env device}} command to switch to the primary CM-T3730 storage:<pre>> env device nand import</pre>
| |
| | }} | | }} |
| | | | |
| | [[Category:U-Boot]] | | [[Category:U-Boot]] |
| | [[Category:CM-T3730]] | | [[Category:CM-T3730]] |
