Difference between revisions of "UCM-iMX8M-Mini: Evaluation Kit: Getting Started"

Revision as of 10:01, 3 March 2019

UCM-iMX8M-Mini evaluation kit is preloaded with Yocto Linux image for UCM-iMX8M-Mini.

Make sure jumpers E6, E9, and E14 are populated (default state).
Make sure jumpers E1, E4, E7, E8, E10, E12 and E15 are removed (default state).
Connect the LCD panel (included in the kit) to connectors P22 and P45. Ensure that the flat cables are fully inserted.
Connect a standard USB cable (included in the kit) between your host PC and the evaluation kit micro-USB2.0 connector P13.
On your computer, start a terminal emulation program (such as HyperTerminal) with the following serial port settings:

Baud Rate Data Bits Stop Bits Parity Flow Control

115200 8 1 none none

Connect the DC 12V power supply adapter (included) to main DC power connector J2.
Follow the messages in your terminal emulator program until you see the linux login prompt.
Use the credentials below to login.

In case of no messages appear in your terminal emulation program, please refer to the detailed USB console guide.

@@ Line 3: / Line 3: @@
 == System setup ==
 UCM-iMX8M-Mini evaluation kit is preloaded with [[UCM-iMX8M-Mini_NXP_iMX8M-Mini_Yocto_Linux|Yocto Linux image for UCM-iMX8M-Mini]].
-# Make sure jumpers '''E6''', '''E9''', and '''E14''' are populated.
+# Make sure jumpers '''E6''', '''E9''', and '''E14''' are populated (default state).
-# Make sure jumpers '''E1''', '''E4''', '''E7''', '''E8''' and '''E15''' are removed.
+# Make sure jumpers '''E1''', '''E4''', '''E7''', '''E8''', '''E10''', '''E12''' and '''E15''' are removed (default state).
 # Connect the LCD panel (included in the kit) to connectors '''P22''' and '''P45'''. Ensure that the flat cables are fully inserted.
 # Connect a standard USB cable (included in the kit) between your host PC and the evaluation kit micro-USB2.0 connector '''P13'''.