Difference between revisions of "UCM-iMX93: Evaluation Kit: Getting Started"
(Created page with "frameless|top|1500px|link= == System setup == UCM-iMX93 evaluation kit is preloaded with the UCM-iMX93 Yocto Linux image. # Make...") |
|||
| (3 intermediate revisions by 2 users not shown) | |||
| Line 1: | Line 1: | ||
| − | [[Image:UCM-iMX93-eval-kit-quick-setup.png|frameless|top| | + | __NOTOC__ |
| + | [[Image:UCM-iMX93-eval-kit-quick-setup.png|frameless|top|1600px|link=]] | ||
| + | |||
| + | == Package content == | ||
| + | |||
| + | [https://www.compulab.com/wp-content/uploads/2023/07/ucm-imx93_eval-kit-content.pdf Package content list] | ||
== System setup == | == System setup == | ||
| Line 5: | Line 10: | ||
# Make sure jumper '''E9''' is populated (default state). | # Make sure jumper '''E9''' is populated (default state). | ||
# Make sure jumpers '''E2''' and '''E7''' are not populated (default state). | # Make sure jumpers '''E2''' and '''E7''' are not populated (default state). | ||
| − | # | + | # Optional - connect the LCD panel (if ordered with the kit) to connectors '''P7''' and '''P8'''. Ensure that the flat cables are fully inserted. |
# Connect a standard USB cable (included in the kit) between your host PC and the evaluation kit micro-USB2.0 connector '''P16'''. | # Connect a standard USB cable (included in the kit) between your host PC and the evaluation kit micro-USB2.0 connector '''P16'''. | ||
| − | # On your computer, start a terminal emulation program (such as | + | # On your computer, start a terminal emulation program (such as Tera Term or PuTTy) with the following serial port settings: |
<blockquote> | <blockquote> | ||
{{:SB-SOM: serial port parameters table}} | {{:SB-SOM: serial port parameters table}} | ||
Latest revision as of 13:14, 19 December 2023
Package content
System setup
UCM-iMX93 evaluation kit is preloaded with the UCM-iMX93 Yocto Linux image.
- Make sure jumper E9 is populated (default state).
- Make sure jumpers E2 and E7 are not populated (default state).
- Optional - connect the LCD panel (if ordered with the kit) to connectors P7 and P8. Ensure that the flat cables are fully inserted.
- Connect a standard USB cable (included in the kit) between your host PC and the evaluation kit micro-USB2.0 connector P16.
- On your computer, start a terminal emulation program (such as Tera Term or PuTTy) with the following serial port settings:
Baud Rate Data Bits Stop Bits Parity Flow Control 115200 8 1 none none
Starting the system
- Connect the DC 12V power supply adapter (included) to main DC power connector J4.
- Follow the messages in your terminal emulator program until you see the linux shell command line prompt.
|
In case no messages appear in your terminal emulation program, please refer to the detailed USB console guide. |
