Difference between revisions of "CM-FX6: Android: Getting started"

Revision as of 13:52, 4 November 2014

The following outlines the procedure necessary to install Android on the CompuLab CM-FX6 System-on-Module / Computer-on-Module.

CM-FX6 may use either SD card (P6) or SATA SSD as root file system.

Properly connected CM-FX6 evaluation kit with valid U-Boot
SD-Card with minimal capacity of 2GB, which will serve as boot medium and root file system
PC workstation for creating bootable SD-Card

On Linux, the instructions below may be used instead:

# dd if=cmfx6-android.img of=/dev/sdc bs=4M

Within 60 seconds the HDMI display should start showing signs of life.

@@ Line 1: / Line 1: @@
 == Overview ==
-The following outlines the procedure necessary to install Android on CM-FX6.
+The following outlines the procedure necessary to install Android on the CompuLab CM-FX6 System-on-Module / Computer-on-Module.
 == Installation target media ==
@@ Line 26: / Line 26: @@
 : Within 60 seconds the HDMI display should start showing ''signs of life''.
-== Post Install Procedure ==
-* On first boot, proceed to '''Settings'''->'''Developer options''', check '''Stay awake ... while charging''' to prevent the device from going to suspended state.
-{{Note|If '''Developer options''' item is hidden (as is the default in Jelly Bean), re-introduce it proceeding to '''Settings'''->'''About tablet''' and clicking on '''Build number''' 7 times consequently.}}
-* Default display configuration may be overridden following the ''display configuration'' [[CM-FX6: Android: Operating instructions | directions]].
 == See Also ==
-* [[CM-FX6: Android: Linux kernel]]
 * [[CM-FX6: Android: Serial console connection]]
+* [[Android: ADB setup]]
 * [https://help.ubuntu.com/community/Installation/FromImgFiles Installing SD Card image]
 [[Category:Android]]
 [[Category:CM-FX6]]