SB-UCM-iMX8: HOWTO: USB Console

From Compulab Mediawiki
Revision as of 18:37, 9 December 2018 by imported>Kirill.kapranov (→‎Setting up your host PC)
(diff) ← Older revision | Latest revision (diff) | Newer revision → (diff)
Jump to: navigation, search


Setting up your host PC

  1. Connect a micro-USB cable (included with the evaluation kit) between the SBC connector P13 to a free USB port on your host PC.
  2. Make sure the CP2104 driver is available with your operating system, otherwise install CP2104 driver onto the host PC from here: https://www.silabs.com/products/mcu/Pages/USBtoUARTBridgeVCPDrivers.aspx
  3. Identify the host PC interface and port you will be using for communication with the SBC:
    • For Linux hosts, the serial port in most cases would be called like one of the following (where n is a positive integer): /dev/ttyUSB0, /dev/ttyUSB1 ... /dev/ttyUSBn
    • For Windows Hosts, the serial port in most cases would be called like one of the following (where n is a positive integer): COM1, COM2 ... COMn
  4. Start a terminal emulation program (such as HyperTerminal on Windows or minicom on Linux).
  5. Within the terminal emulation program, in the serial port configuration section select the port identified in previous step and set the following serial port parameters:
Baud Rate Data Bits Stop Bits Parity Flow Control
115200 8 1 none none

Setting up the Compulab Board

  1. Make sure jumper E4 is not populated.
  2. Start the system by enabling power through the main DC power connector.
  3. Console messages should appear on your host PC through the terminal emulation program.
Retrieved from "https://mediawiki.compulab.com/w/index.php?title=SB-UCM-iMX8:_HOWTO:_USB_Console&oldid=4467"