MCM-iMX93: Evaluation Kit: Getting Started

System setup

MCM-iMX93 evaluation kit is preloaded with the MCM-iMX93 Yocto Linux image.

1. Make sure jumper E5 is populated (default state).
2. Make sure jumpers E3 and E4 are not populated (default state).
3. Make sure that main power switch SW1 is in the OFF position.
4. Optional - use the EB-HDRLVDS adapter to connect the LCD panel (if ordered with the kit) to connectors P13 and P14.
5. Connect a standard USB cable (included in the kit) between your host PC and the evaluation kit console connector P3.
6. On your computer, start a terminal emulation program (such as PuTTY on Windows or minicom on Linux) with the following serial port settings:

Baud Rate	Data Bits	Stop Bits	Parity	Flow Control
115200	8	1	none	none

Starting the system

1. Connect the DC 12V power supply adapter (included) to main DC power jack J1.
2. Toggle the main power switch SW1 to ON position.
3. Follow the messages in your terminal emulator program until you see the linux shell command line prompt.

In case no messages appear in your terminal emulation program, please refer to the detailed USB console guide.

What's Next?

• MCM-iMX93 evaluation kit hardware guide
• MCM-iMX93 development resources