CM-T3530: WinCE: Getting Started

From Compulab Mediawiki
Revision as of 11:34, 23 December 2009 by Mike (talk | contribs) (Installing the demo runtime image)
(diff) ← Older revision | Latest revision (diff) | Newer revision → (diff)
Jump to: navigation, search

Connecting the module

The following picture shows the recommended evaluation kit setup

- CM T35 Properly Connected Image.jpg

Creating a bootable SD card

Follow the steps below:
  1. Insert the SD card into an SD-Reader attached to the desktop computer (an SD-card is supplied with the CM-T3530 evaluation kit).
  2. Download and install HP USB Disk Storage Format Tool, version 2.0.6. Please note that other versions of the utility might not work properly.
  3. Launch the utility.
  4. Choose the settings as shown below.
    HP USB Disk Storage Format Tool Window.jpg
  5. Press "Start".
  6. In the Pop Up message, answer "Yes" to format the SD-card.
  7. When the formating is complete, the following window pops up.
    HP USB Disk Storage Format Tool Format Complete.jpg
  • Copy only the MLO file from the LiveDisk folder (stored in the downloaded zip file) to the SD-Card.


Admolition note.png The CM-T3530 will not be able to boot from the SD-Card unless the MLO file is located in the first sector of the card’s FAT32 partition. Make sure MLO is the first file created on the formatted card
  • Copy the rest of the files from the LiveDisk folder to the SD-Card.

Installing the demo runtime image

  • Insert the bootable SD card into the SD socket (connector P13 on SB-T35).
  • Configure the CM-T3530 for SD-Boot mode. There are two ways to do it:
    • Preferred way: Hold the “SD BOOT” button while booting the device. You should hold the button until the synthetic splash-screen (4 colored squares) appears.
    • Installing jumper E6.
  • Power on the device. The synthetic splash-screen (4 colored squares) will appear on LCD display within a few seconds.
  • An Updater image (dedicated WinCE image) is loaded from the SD-Card. Updater image boot time is approximately 50 seconds.
  • The Updater utility will start automatically. The utility will install the runtime image onto the CM-T3530 NAND flash.
CM T35 Updater Running.jpg
  • The following message box informs you that the process is complete.
CM T35 Updater Complete.jpg
  • Make sure jumper E6 is removed. Otherwise, the installation process will be repeated next time you boot the device.
  • Use the reset button to reboot the device.
  • CompuLab WinCE demo image will be loaded from the NAND flash.

See also

SD/MMC format for OMAP3 boot