Difference between revisions of "CM-T3730: U-Boot: Known Issues"

From Compulab Mediawiki
Jump to: navigation, search
 
 
(One intermediate revision by one other user not shown)
Line 1: Line 1:
 
{{IssueCategory|Multiple environment storage devices|
 
{{IssueCategory|Multiple environment storage devices|
* After switching the environment storage device using {{parameter|env device}} command, U-Boot might print an incorrect message when saving the environment, reporting the destination storage device as the original boot storage device.
+
* After using usb commands in U-Boot, Linux might fail to detect USB devices.
: This can be ignored; the environment will be saved to the correct storage device (as reported by the {{parameter|env device}} command).
+
: '''Workaround:''' Reset the module before booting Linux. This can be done using the reset button (SW2) or the U-Boot command {{cmd|reset}}.
* While using CM-T3730, with on-board micro SD card, on the CB-T3 baseboard or the SB-T35 baseboard, with alternate boot selected, the boot process will default to the CM-T3730 primary storage (micro SD card), but U-Boot will still expect to find the environment in the external NAND flash.
 
: '''Workaround:''' Use the {{parameter|env device}} command to switch to the primary CM-T3730 storage:<pre>> env device mmc import</pre>
 
* While using CM-T3730, with on-board NAND flash, on the CB-T3 baseboard or the SB-T35 baseboard, with alternate boot selected, and the MMC card is not present in the socket, the boot process will default to the CM-T3730 primary storage (NAND flash), but U-Boot will still expect to find the environment in the MMC card.
 
: '''Workaround:''' Use the {{parameter|env device}} command to switch to the primary CM-T3730 storage:<pre>> env device nand import</pre>
 
 
}}
 
}}
  
 
[[Category:U-Boot]]
 
[[Category:U-Boot]]
 
[[Category:CM-T3730]]
 
[[Category:CM-T3730]]

Latest revision as of 17:14, 18 March 2014

Multiple environment storage devices
  • After using usb commands in U-Boot, Linux might fail to detect USB devices.
Workaround: Reset the module before booting Linux. This can be done using the reset button (SW2) or the U-Boot command reset.