Difference between revisions of "CM-T43: Evaluation Kit: Getting Started"

From Compulab Mediawiki
Jump to: navigation, search
Line 21: Line 21:
  
 
= What Next? =
 
= What Next? =
*[[CM-T43 TI AM437x Linux | CM-T43 Linux guide]]
+
*[[CM-T43 TI AM437x Linux|CM-T43 Linux guide]]
*[[CM-T43 Yocto Linux | CM-T43 Yocto guide]]
+
*[[CM-T43 TI AM437x Yocto Linux|CM-T43 Yocto guide]]
 
*[http://www.compulab.co.il/products/computer-on-modules/cm-t43/#devres CM-T43 development resources]
 
*[http://www.compulab.co.il/products/computer-on-modules/cm-t43/#devres CM-T43 development resources]
 
<!--
 
<!--

Revision as of 13:44, 1 May 2016

SB-SOM top view
SB-SOM top view
SB-SOM bottom view
SB-SOM bottom view

System setup

CM-T43 evaluation kit contains an SD card preloaded with Debian Linux image for CM-T43.

  1. Insert the evaluation kit SD card into the SD/MMC/SDIO socket P9 until you hear a clicking sound.
  2. Make sure jumpers E3 and E1 are not populated (default state).
  3. Connect the standard USB cable (included) between your host PC and the evaluation kit micro-USB2.0 connector P7.
  4. On your computer, start a terminal emulation program (such as HyperTerminal) with the following serial port settings: 115200 baud rate, 8 data bits, 1 stop bit, no parity, no flow control.

Starting the system

  1. Connect the DC 12V power supply adapter (included) to J6.
  2. Follow the messages in your terminal emulator program until you see the linux login prompt.
  3. NOTE: in case no messages appear in your terminal emulation program, please refer to the detailed USB console guide.
  4. Use the credentials below to login.
  • username: root
  • password: 111111

What Next?