Difference between revisions of "Compulab Technical Support"

From Compulab Mediawiki
Jump to: navigation, search
 
Line 3: Line 3:
  
 
Please use the following template when you open an issue:
 
Please use the following template when you open an issue:
# State the release date you are using
+
# State the hardware product revision
# Does the problem happen on compulab's eval board?
+
# State the software release date you are using
 +
# Does the problem occur on CompuLab evaluation platform?
 
# What is the symptom (upload a log file)
 
# What is the symptom (upload a log file)
 
# What are you expecting
 
# What are you expecting

Revision as of 15:18, 23 December 2009

Compulab provides support for its products through the online support system. Please refer to the SupportDB help page for information about the system and its use.

Please use the following template when you open an issue:

  1. State the hardware product revision
  2. State the software release date you are using
  3. Does the problem occur on CompuLab evaluation platform?
  4. What is the symptom (upload a log file)
  5. What are you expecting
  6. Steps to reproduce
  7. Additional relevant information

Providing all the above information will enable us to provide faster and more accurate support.


Issue report example

I am using the Windows CE package for CM-X300 released on 13/4/2014, and downloaded from www.anotherinvalidplace.nul.
The following happens on Compulab's eval board (CM+SB):
RTC fails to save the time.
I expect the date and time to persist when doing a software reboot.
To reproduce:

  • turn the module on
  • Set the time and date
  • Reboot the module using Software reboot
  • Check the time

Additional info:

  • Doing the same experiment with a GPIO reset succeeds.
  • The device is powered by the battery when doing this.
  • Plugging the device to the power supply resolves this.


The log file is attached
Thanks,
Someone