View source for CM-T43: Evaluation Kit: Getting Started

[[Image:CM-T43-eval-kit-quick-setup.jpg|800px]]
[[Image:SB_SOM_topview2.jpg|thumb|right|alt=SB-SOM top view|<div align="center">SB-SOM top view</div>]]
[[Image:SB_SOM_bottomview2.jpg|thumb|right|alt=SB-SOM bottom view|<div align="center">SB-SOM bottom view</div>]]

= System setup =
CM-T43 evaluation kit contains an SD card preloaded with [[CM-T43: Linux: Debian|Debian Linux image for CM-T43]].
# Insert the evaluation kit SD card into the SD/MMC/SDIO socket <!-- [[SB-SOM:_Connectors:_P9|P9]] --> '''P9''' until you hear a clicking sound.
# Make sure jumpers <!-- [[SB-SOM:_Jumpers:_E3|E3]] --> '''E3''' and <!-- [[SB-SOM:_Jumpers:_E1|E1]] --> '''E1''' are not populated (default state).
# Connect the standard USB cable (included) between your host PC and the evaluation kit micro-USB2.0 connector <!-- [[SB-SOM:_Connectors:_P7|P7]] --> '''P7'''.
# On your computer, start a terminal emulation program (such as HyperTerminal) with the following serial port settings: 115200 baud rate, 8 data bits, 1 stop bit, no parity, no flow control.

= Starting the system =
# Connect the DC 12V power supply adapter (included) to <!-- [[SB-SOM:_Connectors:_J6_and_J8|main DC power connector - J6]] --> '''J6'''.
# Follow the messages in your terminal emulator program until you see the linux login prompt. 
# '''NOTE:''' in case no messages appear in your terminal emulation program, please refer to the detailed [[SB-SOM: HOWTO: USB Console|USB console]] guide.
# Use the credentials below to login.
:* username: root
:* password: 111111

= What Next? =
*[[CM-T43 TI AM437x Linux | CM-T43 Linux guide]]
*[[CM-T43 Yocto Linux | CM-T43 Yocto guide]]
*[http://www.compulab.co.il/products/computer-on-modules/cm-t43/#devres CM-T43 development resources]
<!--
*[[CM-T43: Evaluation Kit: Hardware Guide | CM-T43 evaluation kit hardware guide]]
-->

[[Category:SB-SOM]]
[[Category:CM-T43]]