Transclusion: IOT-GATE-iMX8: RS485 / RS232

IOT-GATE-iMX8 / SBC-IOT-iMX8 features a RS485 / RS232 port. Only half-duplex mode is supported for the RS485.
The RS485 / RS232 interface is routed to rear panel terminal block connector see drawing.
RS485 / RS232 connector pin-out:

Pin Number	RS485 Functionality	RS232 Functionality
1	NEG A/-	TXD
2	NEG B/+	RTS
3	Ground	Ground
4	NC	CTS
5	NC	RXD
6	Ground	Ground

RS485 / RS232 Mode Selection

The UART mode is stored in the U-Boot environment.
U-Boot environmnet commands are used to set/get the UART mode.

Set RS485 mode

root@iot-gate-imx8:~# cl_setenv uart_mode rs485
root@iot-gate-imx8:~# reboot

Set RS232 mode

root@iot-gate-imx8:~# cl_setenv uart_mode rs232
root@iot-gate-imx8:~# reboot

Get UART mode

root@iot-gate-imx8:~# fw_printenv uart_mode

Example

Serial terminal emulator application can be used to test the RS485 port.

• Use the following command to start Minicom with the user space device of the RS485 (/dev/ttymxc0).

root@iot-gate-imx8:~# minicom -D /dev/ttymxc0

• Follow the following steps to disable hardware flow control
  • Open the menu "Configure Minicom" with CTRL-a followed by the letter 'o'.
  • Select "Serial port setup"
  • Press the letter 'f'.
  • Press the Esc key twice.
• The characters that are typed in the terminal are transmitted to the RS485 port.
• The characters that are received from the RS485 port are displayed in the terminal.
• Press CTRL-a followed by the letter 'x' to exit from Minicom