Difference between revisions of "CM-T43: Evaluation Kit: Getting Started"
| Line 21: | Line 21: | ||
= What Next? = | = What Next? = | ||
| − | *[[CM-T43 TI AM437x Linux | CM-T43 Linux guide]] | + | *[[CM-T43 TI AM437x Linux|CM-T43 Linux guide]] |
| − | *[[CM-T43 Yocto Linux | CM-T43 Yocto guide]] | + | *[[CM-T43 TI AM437x Yocto Linux|CM-T43 Yocto guide]] |
*[http://www.compulab.co.il/products/computer-on-modules/cm-t43/#devres CM-T43 development resources] | *[http://www.compulab.co.il/products/computer-on-modules/cm-t43/#devres CM-T43 development resources] | ||
<!-- | <!-- | ||
Revision as of 13:44, 1 May 2016
System setup
CM-T43 evaluation kit contains an SD card preloaded with Debian Linux image for CM-T43.
- Insert the evaluation kit SD card into the SD/MMC/SDIO socket P9 until you hear a clicking sound.
- Make sure jumpers E3 and E1 are not populated (default state).
- Connect the standard USB cable (included) between your host PC and the evaluation kit micro-USB2.0 connector P7.
- On your computer, start a terminal emulation program (such as HyperTerminal) with the following serial port settings: 115200 baud rate, 8 data bits, 1 stop bit, no parity, no flow control.
Starting the system
- Connect the DC 12V power supply adapter (included) to J6.
- Follow the messages in your terminal emulator program until you see the linux login prompt.
- NOTE: in case no messages appear in your terminal emulation program, please refer to the detailed USB console guide.
- Use the credentials below to login.
- username: root
- password: 111111
