U-Boot for CM-FX6

The CompuLab CM-FX6 module is using U-Boot boot-loader for low-level initializations and operating system loading. U-Boot is an open source firmware for wide range of embedded systems (e.g. PowerPC, ARM, MIPS, x86, ColdFire, AVR32, NIOS, etc.). On this page we will discuss only features and use cases related to CompuLab CM-FX6 module. For more information on U-Boot, please refer to Official U-Boot Homepage.

Resources

Evaluation Firmware Overview Firmware Update U-Boot quick reference Development Building Firmware images U-Boot images U-Boot documentation Troubleshooting Support

News RSS Feed

30-Jun-2014 Initial release of U-Boot for CM-FX6 U-Boot 2014.04-cm-fx6-1 supports: - MMC/SD Card - SPI flash - Ethernet - NAND flash - SATA and on-board SSD - USB host and USB OTG in host mode - Multiple I2C buses - Green LED - Fix NAND detection issue found in older U-Boot versions