SB-UCM: HOWTO: CAN Connection

From Compulab Mediawiki
Jump to: navigation, search
SB-UCM top view
SB-UCM top view
SB-UCM bottom view
SB-UCM bottom view

Description

The CAN bus interface available with the system is accessible through P23 header. P23 pinout is outlined below:

P23 Pin Signal Name Description
1 CAN_VCC (5V) If your CAN bus interface requires 5V or provides more than 5V to node, connect this pin to your CAN bus power terminal.
2 CAN_H Connect to CAN_H terminal your CAN bus interface
3 CAN_L Connect to CAN_L terminal your CAN bus interface
4 CAN_GND Connect to GND terminal your CAN bus interface

120Ω CAN bus termination

CAN bus termination on a node is required with some CAN bus topologies while forbidden with others. SB-UCM board features the E10 jumper which can be used to enable/disable 120Ω CAN bus termination implemented onboard SB-UCM. Set the bus termination most recommended for your CAN bus topology using E10 jumper.

  • Place a jumper cap onto E10 to enable 120Ω CAN bus termination.
  • Remove the jumper cap from E10 to disable 120Ω CAN bus termination.